Tiptop MIXZ - Manual (Page 3)

Tiptop Bus Mix.
3
The Bus Mix is a technology we have developed to mix signals coming from
modules without the use of patch cables to physically connect them to the mixer.
This is done by sending the signal through the bus board and picking them up
by the MIXZ. At this moment this manual is being written the modules that have
Bus Mix are all of the Tiptop drum modules. You can decide which modules
you want to connect to the Bus Mix and which not, at the back of each of the
drum modules there is a 2 or 3 pin header, enabling this header by placing the
jumper to cover both pins will connect this output to the bus. The Bus Mix lets
you turn on and off a mix of drum sounds with a flip of a switch.
To enable your drum
modules for Bus Mix
look for the header
located on the back of
each module and place
the header on both pins.
You can enable some and
disable others to decide
which ones you want to be
mixed by the MIXZ.
Remember, you can always
add them later to the mix
through the front panel
Mixer A and B.