Tiptop µZEUS Flying - Manual (Page 2)

TM
Zeus Series: microZEUS with Flying Bus Boards
The uZEUS is a 4HP power supply module for Eurorack format synthesizers.
This version comes with two (2) flying bus boards that are already attached to
the module. An additional connection is available on the uZEUS for attaching
an extra flying bus board if needed. The flying bus boards use a keyed
connector, ensuring that module power cables can only be connected in the
correct position.
When ordering your uZeus make sure to order a power adapter that fits your
country’s power plug. These adapters are usually offered along side the uZeus
by the shops carrying them in your country.
Connecting the uZEUS:
First, attach your uZEUS to your system. It can be placed in any position along
the rails, but it is strongly recommended that it be placed on the rightmost
edge of your case.
Next, plug the wall adapter in to your mains supply and insert the barrel plug
into the uZEUS. Once connected, turn the switch to the ‘ON’ position and make
sure all three (3) blue lights are illuminated.
If for any reason, one or all of them are not illuminated then immediately turn
the switch to the ‘OFF’ position.
Check all of your connections before continuing. Is the uZEUS in contact with
another object? Are all of the modules plugged in properly?
Once you have successfully powered your uZEUS, all you have left to do now
is play!
It is important to note that the front panel of the uZEUS may get very warm.
Please do not be alarmed as this is normal and is part of the standard operation
of the uZEUS, more on that in the next pages, please continue reading.
WARNING: The internal components of the uZEUS can get
very hot. Do not touch the internal components while the
uZEUS is connected and/or powered.