TK Audio Transceiver - Manual (Page 2)

Adjust the send level so you
don’t overload the pedal, then
use the gain for level make-up
after the pedal.
Hook up a guitar pedal
Use it as a four channel DI-box
Re-amping
1. Hook up your guitar and amp with a “Y” splitter
connected to the Transceiver return. Adjust the
amp for your wanted sound and use the Trans-
ceiver gain control to adjust the level of the direct
guitar signal that feeds your DAW.
2. Lower the send level control and move the
cable that feeds the amp to the send output
instead. Now adjust the send control so you get
the same amp level as you got when the amp
was connected to the “Y” splitter.
See picture to the right.
By connecting the amp this way you can re-
create the sound from this set-up to 100% by
feeding the recorded direct signal to the amp
again (as long as the amp is the same and
controls adjusted the same).
“Y” splitter
Because of it’s high input impedance it’s a
perfect DI-box for bass and passive
instrument microphones.
Impedance and level matching
Use it as a driver when
you like to hook up your
instrument direct to a
low impedance input on
an old vintage unit.
Use your balanced studio
gear on stage.