TracRac IM Toolbox Mount Kits - Manual (Page 3)

TracRac Inc. 994 Jefferson St. Fall River, MA 02721 l 800-501-1578 Instruction Manual
Toyota Tacoma Mount Installation - 34000
Remove the plastic end-caps from the factory 1.
installed rails, front and back.
Take the Tacoma mount clamp and partially 2.
thread a 3/8”-16 hex head cap screw through
the tapped hole located on the bottom of the
clamp.
Slide two clamps into each factory installed 3.
rail from the back end of the truck and replace
the rear end-caps.
Slide two clamps into each factory installed 4.
rail from the front end of the truck and replace
the front end-caps. If installing a toolbox, slide
three clamps into the front of the factory rail.
With the clamps retained in the track now 5.
slide 2 of them on each upright base, the
clamps should be spaced as far a part as
possible.
Reference the placement of the uprights from 6.
the TracONE installation book. With the base
in the desired location place a 3” U channel
on top of the hex head caps screws.
Torque the hex head cap screws down to 14 7.
lb-ft using a 9/16” open end wrench.
Note: The 3” U Channel and 3/8”-16 Hex Head •
Cap Screw are included with the original rack
hardware.
Tacoma Installation (Clamp Set)
Base Unit
U-Channel
Hex Head Bolt
Tacoma Clamp
Factory
Installed
Bed Rail
System
Rubber Shim