TracRac IM T-Rac Pro Tacoma - Manual (Page 2)

Toyota Tacoma T-Rac Pro INSTRUCTION MANUAL 7 TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 800-501-1587
7. Once a set of corners has been loosely tightened to the truck, center the crossbar left to right. Crossbar should fit
flat on the saddle plates, (Figure 8) then tighten the saddle plate T-bolt nuts (Torque T-bolt nuts to 240 in-lbs.).
Next tighten corner brace fasteners to 240 in-lbs. Fully tighten 5/16” bolts on base rail clamps (Torque to 90-110 in-lbs).
Equal Distance Equal Distance
Saddle Plate Corner Brace
Fastener
Crossbar Center
Figure 8. Crossbar Adjustment
8. Now you’re ready to install the crossbar tie downs. Slide the tie-
down, T-bolt first, into the notch in the top of the crossbar
and lock them in place with the knob. (See Figure 9).
Notes:
Although the T-Rac is capable of carrying a maximum of 500 lbs.,
evenly distributed between both racks, the capacity is limited to
the strength of the truck sidewall and road conditions.
For good performance and safety, we recommend re-torquing all
clamps and fasteners to the proper specifications after the first 500
miles and every 5000 miles thereafter.
Carrying high loads over rough roads with excess speed may damage
the system or your truck. Exercise good judgement at all times.
Please review the enclosed CAUTION sheet for additional guidelines.
• We’re confident about the structural integrity of our racks, but less sure about the strength of the new truck beds.
• The solution for greater capacity?
The Original TracRac System, which provides enough support for your truck to handle a full 1,000 Lbs.
Please call us with questions or concerns: 800.501.1587 or email: [email protected]
Figure 9. Crossbar Tiedown install
Toyota T
acoma T
-RacPro_IM_SKU 25000_10.10.07
 Toyota Tacoma T-Rac Pro INSTRUCTION MANUAL TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 800-501-1587
Installation Notes:
• The T-Rac mounts onto the side rails of your truck without drilling.
• Installation is straight forward, and should take approximately 45 minutes to complete.
1. Verify that you have received the correct parts using the assembly drawing and packing list.
Toyota Tacoma T-Rac Pro
2. Slide 6 T-bolts into slot under crossbar.
(3 per side)
Note: The flat recess must face down.
(See Figure 1).
Tools Required
1) Socket Wrench
2) 9/16” Socket
3) 1/2” Socket
4) 5/16” Allen Wrench
Recommended
1) Torque Wrench
Figure 1. Crossbar cross section
TACOMA T-RAC PRO