Treasure Garden AG19 - Manual (Page 6)

2 5
Bottom
Pole
Cantilever Arm
Top Pole
with Canopy
Cantilever Shortened*
Stem
Pole
(Fig. 4)
To ATTACH VEGA Umbrella Light:
Loosen the VEGA light adapter built into the umbrella runner by turning counter-clockwise
(Fig. 17). After loosening, pull down light adapter post (Fig. 18) to attach the
VEGA umbrella light (sold separately).
To OPEN and ATTACH VEGA:
Open the VEGA umbrella light by holding firmly with one hand and then depress the clamp
release button with the other hand to release the clamp lock. Open up the VEGA light and
clasp around the light adapter post (Fig. 19). Snap to close (Fig. 20).
To REMOVE VEGA and CLOSE adapter:
Hold the VEGA umbrella light, depress the clamp release button to release the clamp lock.
Remove VEGA umbrella light, and gently push up the light adapter post back into umbrella
runner and tighten turning clockwise (Fig. 17).
(Fig. 17) (Fig. 18)
(Fig. 19) (Fig. 20)
AG19 Features
(Fig. 1) (Fig. 2)
S T E P 1 Assemble Cross Bar Stand
Set cross bars in a cross position and attach bottom pole stem (Fig. 1) to cross bar
stand with supplied bolts and washers (Fig. 2). Secure with (4) square stones or
concrete weights (weights not included).
IMPORTANT: Cross bar stand will not support umbrella without proper weights.
Using the stand without weights will damage your umbrella.
S T E P 2 Assemble AG19 Frame
Insert the top pole with canopy into the bottom pole until spring locks (Fig. 3). Hold the canopy
closed and slowly lift cantilever upwards until arm is fully extended and spring locks into place
(Fig. 4). Screw the crank handle clockwise into the crank case.
*NOTE: Shortening of the cantilever is merely for packaging purposes or storage.
IMPORTANT: (If cantilever arm does not fully extend, cord maybe coiled too tightly). Two
persons are needed for the following action.
While the first person slowly lifts the cantilever up,
the second person turns the crank handle counter-clockwise, releasing more cord to allow the
cantilever arm to raise until spring locks into place.
(Fig. 3)