Treasure Garden AKZ Series - Manual (Page 4)

8 3
To ATTACH VEGA Umbrella Light: (sold separately)
Loosen the VEGA light adapter built into the umbrella runner by turning counter-clockwise
(Fig. 19). After loosening, pull down light adapter post (Fig. 20) to attach the
VEGA umbrella light (sold separately).
To OPEN and ATTACH VEGA:
Open the VEGA umbrella light by holding firmly with one hand and then depress the clamp
release button with the other hand to release the clamp lock. Open up the VEGA light and
clasp around the light adapter post (Fig. 21). Snap to close (Fig. 22).
To REMOVE VEGA and CLOSE adapter:
Hold the VEGA umbrella light, depress the clamp release button to release the clamp lock.
Remove VEGA umbrella light, and gently push up the light adapter post back into umbrella
runner and tighten turning clockwise (Fig. 19).
NOTE: It is not necessary to
remove light to close umbrella.
(Fig. 19) (Fig. 20)
(Fig. 21) (Fig. 22)
AKZ Features S T E P 1 Rotating Hub Assembly
If you have already installed your rotating hub onto your base or mount kit, please skip to
Step 2.
Remove rotating hub from the main frame by removing the (2) main frame bolts and (2)
washers (Fig. 1), set aside bolts for later use. Now, place rotating hub onto base plate (if
installing onto a mount kit), inverted plate (if installing onto BASE-AKZ) or base frame (if
installing onto BASE-13) (Fig. 2) and tighten with (5) supplied hub bolts and washers
(Fig. 3). BASE-AKZ assembly example shown below.
6mm
Hexagon
Wrench
8mm Hexagon Wrench
(Fig. 2)
(Fig. 1)
(Fig. 3)