Turning Technologies TurningPoint 5 - Manual (Page 9)

PowerPoint Polling Mac
powerpoint
polling
continued
How to Poll in PowerPoint for Mac
Before You Begin
To poll in PowerPoint, you need a presentation with questions slides
or a question list. To track results based on participants, a participant
list is also recommended.
Polling in PowerPoint: Mac Showbar
Minimize
Showbar
Toggle
Response
Count
Show/Hide
Response
Grid
View
Original
Chart
Show/Hide
Connection
Information
Set
Anonymous
Start Polling Repoll
Question
Insert New
Question
Data
Slice
Display
Participant
Monitor
Display
Messaging
Window
Response
Counter
Polling
Status
1. Plug in the receiver or establish a ResponseWare session.
2. Open TurningPoint and select a
participant list and a question list , or a
PowerPoint presentation , if applicable.
3. Click PowerPoint Polling . The TurningPoint Dashboard closes and
PowerPoint opens. If a question list was selected, TurningPoint will
automatically parse the content into polling slides. This may take a few
moments if there are a large number of questions in the question list.
4. Open the PowerPoint presentation that contains the question slides if
content was not selected before PowerPoint was opened.
5. Verify the correct participant list is loaded.
6. Start the Slide Show from the TurningPoint toolbar. Starting the Slide
Show from the PowerPoint toolbar will result in the Slide Show running
as non-interactive.
7. Click Start to open polling.
8. Click Stop to close polling.
a) Press the spacebar, enter/return key or down arrow to advance the slide.
If using a mouse, a mouse click also advances the slide. Alternatively, a
PresenterCard may be used to advance slides and control polling.
9. Continue until the Slide Show is finished.