Two Notes C.A.B. - Manual (Page 29)

Part 5
MIDI
Your TORPEDO C.A.B. can receive MIDI PROGRAM CHANGE (PC) and CONTROL CHANGE (C)
commands sent by any kind of MIDI controller connected to the MIDI IN of the machine.
It is important to set up the TORPEDO C.A.B. so it will be listening to the
MIDI control commands. Please refer to part 5.7 of this manual.
1 PROGRAM CHANGE (PC)
Each preset on the TORPEDO C.A.B. has a single program number. Preset 01 of the machine is
triggered by a MIDI PC 00. You can address the 100 presets (from 01 to 00 meaning 100), with MIDI
PC 00 to MIDI PC 99. That way, it is possible to randomly access the preset by sending the appropriate
MIDI PC number.
2 CONTROL CHANGE (CC)
The following table contains the assignment of the parameters of the machine and the MIDI CC
numbers and values.
Two Notes Audio Engineering TORPEDO C.A.B. 29