Two Notes Wall of Sound III - Manual (Page 19)

Using TORPEDO WoS III
10 EQ
This is a simple yet powerful 5-band EQ. Shift the band frequencies by changing the mode (guitar or bass) so
as to focus on the signal frequencies pertinent for the corresponding instrument.
• EQ Mode: Off, Guitar or Bass. Please refer to the following table for references be-
tween the band and the cut frequencies in each mode.
• Low, LMid, Mid, HMid, High: band frequencies, from lowest to highest.
Band Guitar Mode Bass Mode
Low (shelf) 120Hz 50Hz
LMid (peak) 360Hz 120Hz
Mid (peak) 800Hz 360Hz
HMid (peak) 2000Hz 800Hz
High (shelf) 6000Hz 4000Hz
11 Exciter
An exciter is very useful to give a sound a certain character, or to add presence, or "air", in the sound. The
integrated exciter will allow you to add such features to your tone.
• Exciter: Switch the exciter ON or OFF.
• Gain: Control the amount of effect applied to the sound.
• Freq: Control the center frequency of the exciter. For example, presence for guitar
is usually found at 2 or 3 kHz. Air can be added by placing this frequency at 6 or 8
kHz.
Two Notes Audio Engineering TORPEDO WoS III 18