VAC Phi 220 - Manual (Page 5)

3
UNPACKING & ASSEMBLY
The vacuum tubes and glass covers are packed individually to prevent damage, and must be fitted
to the amplifier before installation can proceed.
Remove the four screws that secure the aluminum top frame to the chassis
pillars using the tool provided. Turn counterclockwise to remove.
Wear the supplied cotton gloves to minimize the chance of fingerprinting
the nickel plated chassis. Wipe any oils off immediately.
Take care to prevent the tool from scratching the chassis.
Remove the top frame.
From each of the four columns remove the tape, which prevented the
nylon setscrews from coming loose during shipment.
Slide the side and rear glass plates into the pillars’ channels.
Note that the rear glass is slightly wider than the side glasses.
The glass will not go all the way to the chassis top, but has a gap at the
bottom for air flow.
Take care not to scratch or break the glass.