VAC Phi 300.1 User Manual
Page 7
6
INSTALLING THE FRONT GLASS AND TOP RAILS
Your amplifier has been shipped with the front acrylic glass and the top rails romoved.
The following steps show how these are installed.
The glass installs in the groove at the top of the fascia.
Insert it at a slight angle, as shown.
Handle the acrylic glass carefully, and do not scratch it. Scratches will show
strongly when the panel is lighted in normal operation. Your panel was
carefully inspected prior to packing.
The panel will rest securely in the groove as shown.
The top tube cage bars have a spring pin in each end.
To install, place one of the spring pins into one of the small dimples
machined into one of the side rails.
In the Illustration, the pin has been located into the left side rail.
To complete the installation, press the bar in the direction of the pin already
inserted, and manoeuver the other end into the corresponding dimple in
the other side rail.
In this illustration, the bar is pressed to the left, while the right spring pin is
set into the dimple in the right side rail.
The amount of protrusion of each pin may be adjusted slightly if needed.
REMINDER:
Do not remove and connect input cables or speaker cables while is amplifier is
running. Doing so risks damage to your loudspeakers or the amplifier.
REMINDER:
Do not operate the amplifier without a loudspeaker or load resistor attached.