Velodyne Digital Drive Series - Manual (Page 13)

www.velodyne.com Digital Drive Series User’s Manual - 7
(6) LFE INPUT – This XlR input jack receives the balanced lFe signal from your receiver or processor.
(7) MIC INPUT – This XlR input jack is for your XlR microphone cable.
(8) EQ OUTPUT LEFT/RIGHT – connect the audio cable from your accessory kit to these jacks: white
plug to LEFT, and red plug to RIGHT.
(9) THRU – These RcA connectors are for sharing the same signal that goes into your subwoofer with
a second “daisy-chained” subwoofer. RCA input comes out of the THRU jack.
(10) OUTPUT – These RCA connectors incorporate the use of an 80Hz 6dB/octave slope high pass
crossover.
(11) LFE INPUT – This RcA input jack is for line-level connection.
(12) REMOTE SENSOR – This connection allows for hook-up of the optional remote control receiver.
with the optional receiver plugged in you will be able to utilize all functions of the remote. Place the
infrared receiver within direct line of sight from your usuallistening position.
(13) VOLUME UP/dOWN – Press the black UP pushbutton to incrementally raise your subwoofer’s
system volume; press the black dOwn pushbutton to incrementally lower your subwoofer’s system
volume. note the use of these buttons during software update.
(14) SPEAkER LEVEL INPUT RIGHT/LEFT – This speaker-level connector allows either banana plug/
jack or exposed wire/terminal connections.