Velodyne VX-10 - Manual (Page 6)

Product Features
• 10" (8.5" piston diameter) subwoofer with 2.0" high-temp voice coil and
40 ounce motor structure
• Adjustable (50 to 200Hz) low-pass crossover
• Line-level (RCA) inputs
• Speaker-level inputs and outputs with spring loaded terminals
• Signal sensing auto turn on/off
• Variable volume control
• Selectable phase control (0° or 180°)
• Frequency response of 36 - 120 Hz (+/- 3dB)
• Low-pass crossover @ 12dB/octave
• Green power on/ Red power standby mode indicator LED
Prepare for Installation
Your new Velodyne subwoofer provides for a number of installation
options. Read all the installation information below in order to determine
which installation option is best for your system. Remember to perform
all installation procedures with system power turned off to prevent
possible damage.
Placement
True subwoofers operate at extremely low frequencies which are primarily
omnidirectional. Keep in mind that frequency response and output level
can be drastically influenced by placement, depending on the acoustic
properties of the listening room. Typically, the optimum location for a
subwoofer is tucked away in a corner of your listening room. This location
will usually offer the greatest output levels and optimum low frequency
extension. The worst location for a subwoofer is typically far away from
any walls, and close to the center of your room. Avoid these locations
when possible. When using a pair of Velodyne subwoofers in stereo, it is
preferable to place each subwoofer by the satellite of the same channel.
Caution! This subwoofer has electronics built into the cabinet. Do not
place the cabinet next to sources of heat such as furnace registers,
radiators, etc. Do not place the unit near sources of excessive moisture,
such as evaporative coolers, humidifiers, etc. The power cord should be
routed in such a way that it will not be walked on, pinched, or compressed
in any way that could result in damaging the insulation or wire.
5
☞
14
☞
The following conditions require service by a qualified technician:
1. The power cord has become damaged.
2. The unit does not appear to operate normally or exhibits a marked
change in performance.
3. The unit has been exposed to water.
4. Some part of the cabinet or circuitry is physically damaged.
SPECIFICATIONS VX-10
Cabinet Design Bass-reflex with built-in power amplifier
Frequency response 36Hz - 120Hz (+/- 3dB)
Crossover frequency 50-200Hz (variable)
Maximum output power 150 Watt (dynamic)
Phase 0° or 180°
Input impedance 1.2K ohm
(for SPEAKER LEVEL INPUT terminals)
65K ohm
(for LINE INPUT jacks)
Sensitivity
Speaker-Level
1.6V
Line 230mV
Speaker 10" (8.5" piston diameter)
Power Supply 120V 60Hz AC
Power consumption 75 Watt
Cabinet (H,W,D) 15" x 12" x 17"
381mm x 304.8mm x 431.8mm
Weight (approx.) 35 lbs.
Specifications are subject to change without notice.
Thank you for purchasing a
Velodyne VX-10 Subwoofer!