Vermona Retroverb Lancet - spring reverb - Manual (Page 5)

Getting Started
To ensure top quality we carefully checked Retroverb Lancet before packag-
ing. Nevertheless, the unit could have been damaged during transportation.
Therefore, we ask you to take a serious look at the unit when unpacking it.
Do not hesitate to contact us, should there be anything unusual on Retro-
verb Lancet itself or its packaging.
You should find the following items in the box:
• 1 Retroverb Lancet unit
• 1 AC adapter (12V / at least 830mA)
• this manual
Connections and Powering
If you came here without any problems, you can finally start up your Retro-
verb Lancet:
1. Connect the provided power supply unit to the 12VAC jack on Retro-
verb Lancet
ATTENTION Only use the included power supply! You may already
own a suitable-looking power supply that offers the
same connector.
However, Retroverb Lancet requires
an AC adapter, not DC! Using an unsuitable power
supply may cause damage to the unit.
2. Connect the INPUT jack of Retroverb Lancet to an appropriate audio
source such as a drum-computer, a groove-box, a synthesizer, a gui-
tar or CD-player.
3. Connect the OUTPUT jack of Retroverb Lancet to an appropriate audio
input of a mixing console, an audio-interface or an amplifier.
4. Start Retroverb Lancet by switching on OVERKILL on the unit’s rear.
The corresponding green LED will be lit.
5. Congratulations, Retroverb Lancet has been started.
Owner's Manual VERMONA Retroverb Lancet
- 5 -