Voodoo Lab Pedal Power 4X4 - Manual (Page 8)

- 6 -
Line 6
Tone Core pedals, plus Pocket POD can be powered from any available 9V
output, or the M5 using any high-current output with a standard black 5.5x2.1mm
barrel cable.
You can power Line 6 modeling pedals, DL4 or MM4, using the 12V outputs with
a red 5.5x2.5mm barrel cable. This does not match the rating of the supplied Line
6 adapter, but does correctly power these pedals. Note that PODxt & HD, M9,
M13 and the JM4 Looper cannot be powered by Pedal Power 4x4.
TC Electronic
TC Electronic’s Nova pedals such as the Delay, Modulator and Reverb are
powered from any high-current 12V output using a standard black 5.5x2.1mm
barrel cable. This does not match the rating of the supplied TC Electronic
adapter, but does correctly power these pedals.
Other TC Electronic pedals which can be powered from a 9V battery, such as the
Classic and TonePrint series can operate from any 9V output.
Eventide
The Eventide stompboxes (TimeFactor, ModFactor, PitchFactor and Space) can
be powered from any 9V or 12V high-current output using the red 5.5x2.5mm
barrel cable. The 12V output does not match the rating of the supplied Eventide
adapter, but does correctly power these pedals.
Important: While you can power the Eventide stompboxes from either 9V or 12V
high-current outputs, do NOT operate two Eventide pedals from the same
isolated section by using both 9V and 12V jacks of the pair. This WILL exceed
the 400mA current rating.