Waldorf Edition - Manual (Page 24)

Waldorf Edition
User Manual 24 Waldorf
higher velocities. This gives an aypical character suitable for effect sounds. The ma-
ximum volume is always set with the Volume parameter.
Pan (Panning) 100%L...Center...100%R
Determines the position in the stereo panorama. When the setting is to the left, the
sound is panned far left; when the setting is to the right, it is panned far right. If you
want to situate the sound in the middle of the stereo panorama, use the Center set-
ting. Because the delay effects are independent from the pan settings, the higher the
proportion of delayed signal in your mix, the less pronounced the panning effect wil
be.
Mix 100:0%...0:100%
This parameter controls the volume ratio between the original signal and the effect
output of the integrated delay effects. If set to 100:0, the dry signal is sent to the
outputs only, so that no effects can be heard. Higher values will increase the effect
signal. At the maximum setting, 0:100, the pure effected signal will be heard.
XOR Group Off, 1, 2, 3
Assigns the selected instrument to one of the three XOR groups. When several
instruments of the same XOR group receive MIDI notes, the sounding instrument will
be muted by the succeeding one. Use this function to program realistic hi-hats,
especially if only the open or closed hat should be heard. This parameter can also be
used to create monophonic synth sounds. When you set the sync parameter in the
filter section to Off and assign different instruments to the same XOR group, the LFO
stays in sync nonetheless, since the same voice is always triggered.
Delay Effect Sections
The Attack offers two independent Modulation Delay effects. These
effects are tied to outputs 1 and 2. When a sound is routed to 1, delay
1 is selected automatically, and similarly delay 2 appears at output 2.
A delay creates repeats of the input signal. The delay time can be set
either in milliseconds or in musical note values if Sync is selected
(this assumes that your host application can send tempo information
to the plug-in). The maximum delay time is 2 seconds. Additionally,
the delay can be modulated.
Time 0ms...2000ms
Sets the length of the delay tap in milliseconds or note values depending on the
Sync
setting (if your host application supports VST 2.4 or higher).