WatchGuard XTM 2050 - Manual (Page 2)

0
1
Getting Started
1
2
• Make sure your computer is configured to use DHCP. When you connect it to the
XTM 2050, make sure it gets an IP address on the 10.0.1.0/24 network.
Run the Web Setup Wizard
• Open a web browser and type https://10.0.1.1:8080 to start the Web Setup Wizard.
NOTE: Because the XTM 2050 uses a self-signed certificate, you may see a certificate warning in your browser.
It is safe to ignore the warning (Internet Explorer) or to add a certificate exception (Mozilla Firefox).
• Log in with the user name admin and the passphrase readwrite.
• Follow the instructions on the screen and complete the Wizard.
NOTE: Your WatchGuard XTM 2050 now has a basic configuration that allows outbound TCP, UDP, and ping
traffic, and blocks all unrequested traffic from the external network.
• Log in to the Fireware XTM Web UI using the user name admin and the configuration
passphrase you set in the Wizard.
Connect your WatchGuard XTM 2050 and Power it On
red
green
Internet
Router