WebDT DT136 User Manual
Page 2
DT136
ENGLISH
2
3
ENGLISH
The DT136
Powering ON and OFF
The Power Button is located in the front of the DT136. The Power Button may be configured to
function differently depending on the power options of the operating system. In general, to turn the
DT136 on, push and release the Power Button on the front bezel. The power LED will be lit (blue)
and the corresponding interface will be displayed on the display monitor.
To turn off the device, again depending on software operating system, push and release the Power
Button or use a software shutdown interface. In the event of system lockup, the Power Button may
be used to perform a reset on the device. To do that, push and hold the Power Button for at least 4
seconds. The system will shut down and all unsaved work may be lost. Pushing on the Power Button
again will restart the device.
Device Ports
The DT136 features an optimal set of I/O ports while preserving the compact size of the system.
The video-out connectors, network (10/100/1000 BaseT Ethernet), COM ports, and power ports
are supplemented by a set of four USB 2.0 and two audio ports. Through its USB ports, the DT136
supports a wide range of USB-based peripherals. These peripherals are applicable in providing the
means for software installation, application storage, data storage, and system software recovery
and updates.
Memory and Storage
The DT136 may be available in storage configurations ranging from 32GB, 64GB or 128GB Flash.
Depending on base software configuration, the user may use the internal memory of the DT136 for
user’s installed software and storage. The user may also supplement storage space with USB-based
peripherals such as flash disks. RAM capacity is from 4GB to 8GB.
Precautions
Always exercise care when operating and handling the DT136.
•
Never disassemble any portion of the enclosure. It will void any product warranty on the DT136.
•
Do not use any AC/DC adapter other than the one provided with the device or acquired from the
•
manufacturer or its partners.
In the unlikely event that smoke, abnormal noise, or strange odor is present, immediately power
•
down the DT136 and disconnect all power sources.
Please report the problem to your device provider immediately.
•
Rear View
Front View
B
A
C
D
F
E
G
H
RS232 COM ports
USB 2.0 ports
Audio jacks
Power button
E
F
G
H
A
C
B
D
DisplayPort++
DVI port
Ethernet ports
DC-in