WebDT DT509 - Manual (Page 2)

DT509
ENGLISH 2 3 ENGLISH
Precautions
Always exercise care when operating and handling the DT509. •
Never disassemble any portion of the enclosure, as this will void any product warranty on the •
DT509.
Do not use any AC/DC adapter other than the one provided with the device or a replacement
•
acquired from the manufacturer.
In the unlikely event that smoke, abnormal noise or strange odor is present, immediately power
•
down the DT509 and disconnect all power sources. Please report the problem to your device
provider immediately.
Basic Features
The DT509 integrates a bright and responsive touch display, two USB ports, and is complemented
by a suite of options including a magnetic stripe reader (MSR), 2D barcode scanner, RFID reader,
presence sensor and scanner auto-detection for comprehensive point-of-service applications.
Powering ON and OFF
The DT509 is programmed to Power On automatically when power is first applied or re-established.
To turn off the device, use the software shutdown interface provided, or unplug the device.
In the event of system lockup, unplug and then re-plug the power cable.
Calibration
The touch display for the DT509 is calibrated before shipping. In the event that the calibration has
been modified or is unsatisfactory, the respective calibration routines (e.g., PenMount (PM) for
Windows XP) to calibrate the touch interface may be used. Such applications are typically executed
through touch input via Stylus or through mouse click via a USB mouse.
I/O Panels
The DT509 has a comprehensive set of I/O ports. The following ports are located along the lower
rear edge of the display unit.
Options
The DT509 has a number of optional modules. These include:
Magnetic stripe reader (MSR) •
Presence sensor and scanner auto detection •
2D barcode scanner •
RFID reader •
Wi-Fi networking •
A
A
B
B
C
C
D
D
E
E
Mic and line-out jacks
USB ports x 2
Ethernet port
DC-in jack (AC/ DC)
Phoenix connecter (DC/ DC)