Wharfedale Pro XO-206X - Manual (Page 7)

XO
6
SETTING UP
The XO-Series Crossovers are easy to install and operate.
Before plugging in the XO-Series Crossovers, or any electrical audio device, be sure that the
power switch is in the off position, the volume control is all the way down (at 0 level) and all audio
connections are made.
After power-up you will need to set up the system, setting the crossover frequencies. Avoid
distortion (overdriving the input) as it can damage your system, both instantly and in the long term.
CONNECTIONS / WIRING
Connecting XO-Series Crossovers to your system is straightforward. You simply plug in your cables
from the output of the mixer to the input of the crossover; then from the crossover output to the next
component in your system, usually an amplifier. Always use good quality microphone (2 conductor
+ shield) cable. After you plug in the components, you must adjust the crossover frequencies and
their relative levels to produce the best sound.
XO-series User Manual.indd 7 2009-8-11 16:43:51