Wharfedale Pro Contact 800T - Manual (Page 11)

9
Contact 800T
RECEIVER SETTINGS
Verify that the ‘VOLUME’ control setting is at its minimum (fully
counterclockwise).
With the microphone still turned OFF, Press and hold the
‘POWER’ button on the front panel of the receiver until the
LED display lights up.
Once the display is fully illuminated, press the ‘MENU’ button,
repeatedly, until the “G/CH” icon is highlighted. The display will
read the currently selected “GROUP” number and “CHANNEL”
number. These settings can be changed with the UP/DOWN
buttons. It is not necessary to change these settings in order
for the system to work, but they can be changed if any signal
interference is experienced. See the Appendix for Group /
Channel / Frequency assignments.
To change the ”GROUP” setting, press the “up” button (next
to the ‘VOLUME’ knob) repeatedly until the desired “GROUP”
number is displayed. There are 9 Groups available.
To change the ”CHANNEL” setting, press the “down” button
(next to the VOLUME knob) repeatedly until the desired
“CHANNEL” number is displayed. See the Appendix for
Group/Channel correlations.
Once these settings are made, turn the microphone on and
press the ‘SYNC’ button and the receiver will automatically
synchronize with the microphone transmitter at the selected
Group/Channel frequency assignment. The synchronization
is successful when the “RF” level meter shows a signal
indication. The “AF” meter will respond to any sounds being
picked up by the microphone. Speaking into the mic should
show significant audio level indications on the “AF” meter.
Other indications on the receiver’s display will also indicate
“TX” (transmit) and one of the “A” or “B” antenna indicators will
Contact 800T User Manual.indd 9 2010-10-21 17:34:46