Wisdom Audio Sage Series C38 - Manual (Page 11)

11
Unpacking & Installing the
C38m
The Wisdom Audio Sage C38m on-wall speaker is a substantial piece of equip-
ment. Please exercise caution when unpacking your C38m to ensure that you
do not strain yourself from its (perhaps unexpected) weight.
Caution! Do not attempt to lift your C38m while bending or twisting from the
waist. Use your legs for lifting, not your back.
Always stand as straight as possible and keep the C38m close to your
body to reduce strain on your back.
The loudspeaker is packed in a “telescoping” box (two five-sided boxes, one of
which fits snugly inside the other). Gently roll the box over so that its bottom is
facing up. Then carefully cut the tape along the bottom of the box on all four
sides. Roll the box over again so the bottom is on the floor, and lift off the top.
With one person at each end, carefully lift the speaker out of the box and lay it
on a soft surface (carpet or similar).
Mounting the C38m on the wall The mounting bracket that mounts to the wall is shipped attached to the back of
the loudspeaker. It is removed by pulling “down” on it relative to the end of the
speaker that will be “up” when installed on the wall. (Note that for horizontal
center channel speakers, this means the bracket is pulled across the narrow di-
mension of the speaker.)
Please note that this guide assumes the wall surface is flat. If not, shims must
be applied to the rear of the mounting bracket so that the mounting bracket is
uniformly secured to the wall and flat (not distorted). The mounting steps are as
follows:
1. Locate the area with the two sets of high- and low-pass speaker
cables coming out of the wall.
2. The inside face of the bracket assembly has arrows stamped into
it indicating which direction must be “up” when it is mounted on
the wall. Align the center screw hole in the mounting bracket next
to the speaker cables and attach somewhat loosely using a dry-
wall screw (or similar), so you can adjust the bracket for plumb.
3. Using a bubble level to ensure that the mounting bracket is
plumb, mark screw holes for EZ-Toggle screws in end clips, using
the bracket itself as your template. You can use any opposing (di-
agonal) set of holes for mounting of the two EZ-Toggle screws in
each end clip.