Woodhaven 4950: Half Cut-Off Sled - Manual

BEFORE BEGINNING
Identify and verify that you have all the parts listed and
read thru the instructions at least once before beginning. All
set-up work should be done with the saw disconnected from the
power and the saw blade lowered below the table. This unit is
designed for table saws with at least a 27" deep table. Do not
attempt to use on table saws with smaller tables unless you have
adequate support. If necessary, add additional supports to your
saw to prevent the saw from tipping. This unit relies on the
miter slot of your saw being parallel to the saw blade for it to
work properly. If this is not the case, make those adjustments
to your saw first. You'll need a #2 & #3 Phillips screwdriver
for assembly. Turn page over for assembly instructions.
Parts List:
Please identify and verify that you have all of the
hardware shown below prior to assembly.
Part Description Quantity
4951D MDF Base . . . . . . . . . . . . . . . . . . . . . . . . . 1
4918B 17-3/4" Miter Bar . . . . . . . . . . . . . . . . . . 2
4424 24" Ultra Track . . . . . . . . . . . . . . . . . . . . 1
4951C 24" Sub-Fence . . . . . . . . . . . . . . . . . . . . . 1
4951S Straight Flip Stop . . . . . . . . . . . . . . . . . . 1
3724R 24" Right to Left Tape . . . . . . . . . . . . . . 1
4950
Cut-Off Sled
Please Read Carefully!
Part# Description Qty.
5771B 3/4"
Screw 2
Part# Description Qty.
5760B Oval
Nut 6
Part# Description Qty.
MF010 3/4"
Screw 4
1
Part# Description Qty.
5590 Knob 1
Part# Description Qty.
BUSH004 5/8" Spacer
1
Part# Description Qty.
HB030 1"
Bolt 1