Wunder Audio CM7GT User Manual
Page 3
Replacing Fuses
The fuse protecting the
primary circuit
is located outside the PSU.
Unscrew the black fuse cover to open the fuse compartment. Replace
the fuse with a new fuse of the same type (T 100 mA) and close the
fuse compartment lid.
Power Connector
Especially on tour, you may need to connect the unit to a power outlet
that does not match the power connector on the supplied power
cable. Purchase a matching power cable locally that complies with
IEC and local safety standards and has a power connector with a
chassis ground pin. While in the same area, use this “local“ power
cable only.
3. Specifications of the Microphone
Directional Characteristics: Omni-, cardioid- Figure Eight
Cardioid (25 mV/Pa; 20 - 18,000 Hz)
Omnidirectional (14 mV/Pa; 20 - 18,000 Hz)
Electrical Impedance: 200 ohms
Powering: Via the included powering unit with 115/230 VAC
Maximum Sound Pressure Level: 128 dB
Connector: Large-sized Tuchel, 6 pin
Dimensions:
240 mm
(9.45'')
63 mm
(2.48''
)
Shipping Weight: Approx. (~12 Ibs.)
Included Accessories: