XAIRCRAFT X450 Pro - Manual (Page 17)

电路安装完成后，请勿安装螺旋桨，进行X450 Pro无桨通电测试。
1 将遥控器油门收到最小后打开遥控器开关。
2 X450 Pro接通电源。
3 轻推油门。
4 观察四个电机启动是否顺畅，旋转方向是否正确。
a) 如果电机没有启动或启动不畅，则将油门收到最小，断开X450 Pro的电源，检查电路和电机后重新测试，直到正常。
b) 如果旋转方向不正确，则将油门收到最小，断开X450 Pro电源，对调任意两条电机线，直到电机旋转方向都正确。
5 推动各操纵杆，观察电机的转速是否有变化。
6 测试完成，将油门收到最小，断开X450 Pro的电源。
无桨通电测试 Power-on Test without Propellers
After electronic parts installation, DO NOT
1 Lowest the transmitter throttle then turn on the transmitter.
2 Power on X450 Pro.
3 Apply the throttle slowly.
4 Note if four motors rotate smoothly.
a) If motor does not rotate or not smoothly enough, please throttle down to the lowest then power off X450 Pro. Check on
electronic circuit and motors to retest until it works fine.
b) If not in the right direction, lower the throttle to minimum and power off X450 Pro. Swap any motor wire of three
connecting to the holes until it works in the right way.
5 Poke all control sticks to observe motor rotation speed changes or not.
6 Throttle back to lowest and power off X450 Pro.
install the propellers and follow in steps.
15