XAIRCRAFT FC1212-P - Manual (Page 20)

17 / 36
General Input and Calibration
1. Flight Mode (Input 5): flip the Flight Mode switch on transmitter, check the mode shown on software and
remember the position of the switch.
2. Calibration :if signal of throttle does not vary in full range when moving the throttle stick, or roll /pitch/yaw
signal is not right at the red neutral line（e.g.: ）, need to do the RC Calibration,
click Calibrate button and follow the steps to calibration RC.
REV TEST: Check the Response of Transmitter Control
Click the REV Test button on the bottom, viewing the simulator diagram in the prompt window to check with your
RC operation is consistent. if throttle , pitch , roll and yaw are not consistent with your stick operation, then select
Rev option. Click Save button to save your settings.