Bose Wave Music System III - Manual (Page 19)

English – 19
P ERSONALIZING Y OUR W AVE ® M USIC S YSTEM III
Adjusting the display
brightness
The brightness level of the display automatically adjusts
itself for low and high ambient light conditions. This
feature brightens the display for better visibility in high
ambient light conditions and dims the display making it
less intrusive in low ambient light conditions. High and
low brightness settings can be set independently.
1. Press and hold Alarm Setup (Menu)
until -SETUP MENU- is displayed.
2. Press Tune/MP3 > five times until
BRIGHT HI- is displayed.
3. Press Time – or Time + to set the
high display brightness level to a
value from 8-15.
4. Press Tune/MP3 > once until
BRIGHT LO- is displayed.
5. Press Time – or Time + to set the
low display brightness level from 1-8.
6. Press Alarm Setup (Menu) to exit
the setup menu or wait 10 seconds for
the setup menu to exit automatically.
Setting the room code
Your Wave ® music system
III comes from the factory
ready to operate as a second room (room code B) when
connected to a Bose
® link enabled Lifestyle ® system. If
you want to use your Wave ® music system
III with your
Lifestyle ® system beyond a second room you will need to
change the room code to match that of the remote
control you are using for that room.
Refer to your Lifestyle ® system owner’s guide for more
information on room codes.
1. Press and hold Alarm Setup (Menu)
until -SETUP MENU- is displayed.
2. Press Tune/MP3 > seven times until
ROOM- B is displayed. The
dashes following the room letter indi-
cate how the microswitches should
be set on the Lifestyle
® remote
control.
3. Press Time – or Time + to select a
room code other than room B.
4. Press Alarm Setup (Menu) to exit
the setup menu or wait 10 seconds for
the setup menu to exit automatically.
Turning the touch pad
on or off
If you do not wish to use the touch pad feature you can
turn it off.
1. Press and hold Alarm Setup (Menu)
until -SETUP MENU- is displayed.
2. Press Tune/MP3 > eight times until
TOUCH PAD- is displayed.
3. Press Time – or Time + to select
OFF or ON.
4. Press Alarm Setup (Menu) to exit
the setup menu or wait 10 seconds for
the setup menu to exit automatically.
Changing the system
standby timeout
1. Press and hold Alarm Setup (Menu)
until -SETUP MENU- is displayed.
2. Press Tune/MP3 > nine times until
AUTO OFF- is displayed.
3. Press Time – or Time + to select NO
or YES.
4. Press Alarm Setup (Menu) to exit
the setup menu or wait 10 seconds for
the setup menu to exit automatically.
Seine_A_OG.book Page 19 Wednesday, November 9, 2011 9:04 AM