Pontiac 2002 Grand Prix - Manual (Page 166)

3-7
3. Tune in the desired station.
4. Press and hold one of the six numbered pushbuttons
until SET appears on the display. Whenever you
press that numbered pushbutton, the station you set
will return.
5. Repeat the steps for each pushbutton.
Setting the Tone (Bass/Treble)
BASS: Slide the lever to the right or left to increase
or decrease bass.
TREBLE: Slide the lever to the right or left to increase
or decrease treble. If a station is weak or noisy, you may
want to decrease the treble.
Adjusting the Speakers (Balance/Fade)
BAL (Balance): Press this knob lightly so it extends.
Turn this knob to move the sound to the left or right
speakers. The middle position balances the sound
between the speakers.
FADE: Press this knob lightly so it extends. Turn
this knob to move the sound to the front or rear
speakers. The middle position balances the sound
between the speakers.
Press these knobs back into their stored positions when
you’re not using them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that
are up to 30 to 45 minutes long on each side. Tapes
longer than that are so thin they may not work well in
this player.
While the tape is playing, use the VOL, FADE, BAL,
BASS and TREBLE controls just as you do for the
radio. The display will show an arrow to show which
side of the tape is playing. When the down indicator
arrow is lit, selections listed on the bottom side of the
cassette are playing. When the up arrow is lit, selections
listed on the top side of the cassette are playing. The
tape player automatically begins playing the other side
when it reaches the end of the tape.
If an error appears on the display, see “Cassette Tape
Messages” later in this section.
1 PREV (Previous): Press this pushbutton or the SEEK
down arrow to search for the previous selection on the
tape. Your tape must have at least three seconds of
silence between each selection for previous or seek to
work. Press PREV or the SEEK down arrow to stop
searching. The tape direction arrow blinks and the sound
will mute during previous or seek operation.