Pontiac 2002 Bonneville - Manual (Page 88)

2-25
Canadian Owners: If you lose or damage your keys,
only a GM dealer can service PASS
- Key III to have new
keys made. To program additional keys you will need
two current driver’s keys. You must add a step to the
following procedure. After Step 2, repeat Steps 1 and 2
with the second current driver’s key. Then continue
with Step 3.
To program the new key, do the following:
1. Verify that the new key has “PK3” stamped on it.
2. Insert the current driver’s key in the ignition and
start the engine. If the engine will not start, see your
dealer for service.
3. After the engine has started, turn the key to OFF, and
remove the key.
4. Insert the key to be programmed and turn it to ON
within 10 seconds of removing the previous key.
5. The SECURITY telltale light will turn off once the
key has been programmed. It may not be apparent
that the SECURITY light went on due to how
quickly the key is programmed.
6. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the SECURITY light comes
on and stays on, you will be able to restart your engine
if you turn it off. Your PASS
- Key III system, however,
is not working properly and must be serviced by your
dealer. Your vehicle is not protected by the
PASS
- Key III system at this time.
If you lose or damage a PASS - Key III key, see your
dealer to have a new key made.