MagnaFlow HONDA CIVIC Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15233
2013 Honda Civic 2.4L Coupe
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
07/17/13
Rev: 000
Step 1: (Carefully read all instructions before
installation) Begin removal of the OEM exhaust
system by unbolting the inlet flange from the catalytic
converter. Do not damage or discard the OEM
fasteners or rubber insulators, as they will be used to
mount the new exhaust system. Disengage the welded
hangers from the OEM rubber insulators and remove
the entire OEM exhaust system.
Step 2: Install the new exhaust system front to rear.
Attach the Inlet Pipe Assembly to the catalytic
converter outlet using the OEM fasteners and insert
the welded hanger into the OEM rubber insulator.
Leave all clamps loose for the final adjustment of the
complete system. Using the supplied 2.50" clamps,
install the Resonator and Muffler Assemblies in a
similiar fashion.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Inlet Pipe Assy.
Resonator Assy.
Muffler Assy.
[2] 2.50" Clamps