MagnaFlow SCION TC Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1:(Carefully read all instructions before
installation) Begin removing your OEM exhaust
system by first unbolting the muffler inlet pipe at the
flange from the catalytic converter assembly.
Working front to rear remove the welded hangers
from the rubber isolators and remove the whole
system. Be sure to retain all mounting hardware and
rubber as it will be needed to install your new
MAGNAFLOW system.
Step 2: Install your new exhaust system by first
bolting the inlet flange of the muffler assembly to the
catalytic converter assembly using the OEM
fasteners to secure. Locate the welded hangers to
the rubber isolators. Slip the inlet of the tail pipe
assembly over the outlet of the muffler assembly.
Loosely secure using the supplied clamp.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15487
2011 Scion TC 2.5L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Dec 30, 2010
Rev: 000
Muffler Sub Assembly
Tail Pipe Assembly
2.25" Clamp