Ryobi P320 - Manual (Page 11)

11 — English
NOTE: ILLUSTRATIONS START ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a Three-year Limited Warranty.
For Warranty details go to www.ryobitools.com
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Work-contacting element does not
depress fully - tool does not operate. Low nails
Work-contacting element is jammed Replenish nails
Remove battery and clear debris
Tool operates properly, but fasteners do
not drive fully Air pressure is too low
Depth of drive isn’t deep enought
Nail is too long for wood hardness Increase air pressure
Adjust depth of drive
Use nail length that is appropriate for
wood
Tool operates properly, but fasteners are
driven too deep Air pressure is too high
Depth of drive is too deep Decrease air pressure
Adjust depth of drive
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Tool stops and LED’s flash rapidly Battery is low or has no charge.
Tool is hot Recharge battery
Allow tool to cool
Tool has charged battery and LED’s
are slowly flashing or LED’s do not turn
off after approximately ten seconds of
non-use. Tool has malfunctioned Take tool to nearest authorized repair
center