Ryobi S630D - Manual (Page 10)

10 - English
OPERATION
 Unplug the sander.
 Remove dust bag assembly from sander. To remove,
grasp adaptor and pull straight out.
 Remove dust bag from dust bag adaptor.
 Shake dust bag to empty.
 Place dust bag back on dust bag adaptor.
 Attach dust bag assembly back on sander.
REMOVING SANDPAPER BEFORE STORAGE
Do not store the sander with pressure sensitive adhesive
sandpaper installed. Heat generated from sanding causes
the pressure sensitive adhesive to flow and form a tight bond
between the cushion and sandpaper.
Removing the sandpaper soon after you have finished a
sanding operation avoids letting the adhesive set up. If the
sandpaper is left on the cushion for an extended period of
time after use, the adhesive will set up and cause the sand-
paper to become difficult to remove.
It may also tear when removing. When this situation occurs,
it becomes difficult to clean the cushion for the next piece
of sandpaper.
NOTE: If you forget to remove the sandpaper after a sand-
ing operation, sand for a few minutes to soften the adhesive
backing before attempting to remove sandpaper.
MAINTENANCE
Electric tools used on fiberglass material, wallboard, spack-
ling compounds, or plaster are subject to accelerated wear
and possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommend
using this product for extended work on these types
of materials. However, if you do work with any of these
materials, it is extremely important to clean the product
using compressed air.
LUBRICATION
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore, no further
lubrication is required.
POWER SUPPLy CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 11 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.