Ryobi MC100L - Manual (Page 6)

6 — English
FEATURES
PRODUCT SPECIFICATIONS
Motor ........................................................................4 V DC
Blade Stroke ....................................................... 3700 SPM Cutting Capacity
for Soft Metals ....................................... 0.012 in. (0.3 mm )
KNOW YOUR SNIPS
See Figure 1, page 9.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ASSEMBLY
UNPACKING
This product has been shipped completely assembled.

Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Snips
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
SWITCH TRIGGER AND LOCK OUT BUTTON
The switch trigger and the lock out button, located on the
handle, must be depressed simultaneously to allow blade
movement.