Ryobi WS750L - Manual (Page 10)

10 — English
UNPACKING
See Figure 5, page 20.
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
This new product has been shipped in a partially as-
sembled condition as described below. Carefully check
the packing list below to ensure all items are included in
the package; the packing list describes all loose items
that are not assembled to the product as shipped. Do
not operate the product if any packing list items are
already assembled to your product when you unpack it.
Call the customer service number below for assistance.
Operation of a product that may have been improperly
preassembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you ha ve care-
fully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental start-
ing and possible serious personal injury.
ASSEMBLy
INSTALLING WHEELS
See Figure 6a and 6b, page 21.

Place the water tray frame on a flat, stable surface.
 Slide the axle through each of the holes on one end of
the frame.
 Thread a sleeve and a large washer over one end of the
axle.
 Insert the axle through the holes in section 1 of the leg
stand.
 Slide a washer and a wheel over the axle.
 Slide a small washer over the axle.
 Insert a small bolt into the end of the axle. Tighten the
bolt securely.
 Install the other wheel on the opposite side.
ASSEMBLING THE LEG STAND
See Figure 7, page 21.
Leg sections 2 and 3 are pre-installed on the frame.

Slide leg sections 2 and 3 along the frame so that they
are positioned opposite the wheel end.
 Insert the H-bar leg section 6 into sections 2 and 3. The
angled lower leg sections should be pointed outward and
away from you.
 Working from the wheel end of the frame, insert leg sec-
tion 4 into leg section 1 on the left side of the frame.
 Insert leg section 5 into leg section 1 on the right side
of the frame. The angled lower legs (4 and 5) should be
pointing outward and away from you.
 Insert a bolt through the square hole from the inside of
leg section 2. Thread a spacer over the bolt, between the
two legs.
 Insert the bolt through the holes in leg section 1.
 Thread a washer over the bolt. Secure the bolt with a nut
and tighten securely. Repeat on the opposite side.
Push down on the legs until the lock knob underneath the
tray locks into place and the legs are secured.
Make sure that all leg sections are securely tightened before
turning the frame over to install the motor head assembly.
NOTE: The ridged area on the end of the frame may be used
as a handle for moving and transporting the saw.