TAMKO AWA NAILBASE - Manual

PRODUCT DATA
© 2012 TAMKO Building Products, Inc. TAMKO ® is a registered trademark of TAMKO Building Products, Inc.
tamko.com
Corporate 220 West 4th Street, Joplin, Missouri 64801 800-641-4691
Central District 220 West 4th Street, Joplin, Missouri 64801 800-641-4691
Northeast District 4500 Tamko Drive, Frederick, Maryland 21701 800-368-2055
Southeast District 2300 35th Street, Tuscaloosa, Alabama 35401 800-228-2656
Southwest District 7910 South Central Expressway, Dallas, Texas 75216 800-443-1834
Western District 5300 East 43rd Avenue, Denver, Colorado 80216 800-530-8868
Information included in this product data sheet was current at time of printing. To obtain a copy of the most current version of this product data sheet, visit
us online at tamko.com or call us at 800-641-4691.
This product is covered by a 5-year limited material warranty. For information regarding or a copy of TAMKO's limited warranty, contact your local
TAMKO representative, visit us online at tamko.com, or call us at 800-641-4691.
AWA NAILBASE
Fiberglass SBS Modifi ed Base Sheet
GENERAL APPLICATION INSTRUCTIONS
THIS PRODUCT IS FOR APPLICATION ONLY IN LIMITED STATES AND COUNTIES LISTED BELOW:
(1) IN THE STATES OF ALABAMA, ARKANSAS, ARIZONA, FLORIDA, GEORGIA, LOUISIANA, MISSISSIPPI, NEW
MEXICO, NORTH CAROLINA, OKLAHOMA, SOUTH CAROLINA, TENNESSEE, TEXAS, (2) IN THE FOLLOWING
COUNTIES IN THE STATE OF NEVADA: CLARK, ESMERALDA, AND NYE, AND (3) IN THE FOLLOWING COUNTIES IN
THE STATE OF CALIFORNIA: ALAMEDA, CONTRA COSTA, IMPERIAL, INYO, KERN, KINGS, LOS ANGELES, MARIN,
MERCED, MONTEREY, NAPA, ORANGE, RIVERSIDE, SACRAMENTO, SAN BENITO, SAN BERNARDINO, SAN DIEGO,
SAN FRANCISCO, SAN JOAQUIN, SAN LUIS OBISPO, SAN MATEO, SANTA BARBARA, SANTA CLARA, SANTA CRUZ,
SOLANO, SONOMA, STANISLAUS, VENTURA, AND YOLO.
For more information visit tamko.com. The limited warranty for this product only applies in the permitted states and counties.
Otherwise, this product is sold "AS IS" and without warranty of any kind including any implied warranty or condition of
merchantability or fi tness for particular purpose. See TAMKO's limited warranty for complete details.
Apply materials only in fair dry weather when the interface temperature (air, roof deck, membrane) is a minimum of 45
o F and rising.
STORAGE OF AWA NAILBASE:
All roofi ng materials must be properly stored in a dry location prior to application. Store materials on platforms off the ground or roof
deck and covered with opaque waterproof tarps that have been properly tied down. During cold or damp environmental conditions,
place the rolls in a heated area. Do not remove wrapper from the roll until ready to use. Wet or damp roofi ng materials must never
be used in the construction of a TAMKO roof assembly. To prevent the rolls from becoming deformed or damaged, store them in a
standing position with the labels right side up and not double stacked. If rolls become deformed, unroll the rolls on the roof and allow
the sun to relax them. Any areas where accidental damage occurs to a roll must be cut out before the material is installed.
ROOF DRAINAGE:
Proper and adequate drainage of roof surfaces is critical to performance of this product. A minimum roof slope of ¼ in. per ft. is
recommended. Positive drainage is required and is the responsibility of those involved in the design and construction of the roof deck
and supporting structure.
INSULATION:
The insulation (if applicable) should be installed according to the manufacturer’s specifi cations in the thickness required. The insulation
should conform to TAMKO requirements.
Consult the current TAMKO Commercial Roofi ng Specifi cations and Details Manual for specifi cation options available online at www.
tamko.com/commercialspecs.