TAMKO Evergrain - Manual

EG 1•2•3 Hidden Fastener
Installation Instructions
Place first deck board on frame joists in the location where it will be
installed. Once in position, flip board over being careful not to move the
board side to side from position. Install with board screws to the deck
board directly above each joist. Make sure spacing tabs are pointing
downward.
CAUTION: Use low torque setting to avoid spinout.
IMPORTANT: EG 1•2•3 PRODUCT INFORMATION
TOOLS & MATERIALS NEEDED
STEP 1. INSTALLING FIRST FASTENERS STEP 3. INSTALLING FIRST BOARD
Start installation at the house and work toward the outer edge of the
deck. Start by attaching a fastener to the ledger board with spacing
tabs pointing downward. Use a joist screw through hole B while
allowing hole A to extend over the ledger board as shown. (These will
be affixed at a later step.)
Power screw gun with
ratcheting torque setting
1 1/2" JOIST Screws
(included in packaging)
EG 1-2-3 Fasteners
(included in packaging)
Flip first board back over; align the fastener with framing joist, and
install a joist screw through hole A and into the deck frame.
Attach board edge closest to house by installing a board screw through
hole A of each fastener up into the bottom of the deck board. (Secure
the fasteners installed in Step 1.)
NOTE: It is only required to install a board screw into the fastener
from underneath the board on the FIRST and LAST board.
STEP 2. POSITION FASTENERS STEP 4. COMPLETING INSTALLATION OF FIRST BOARD
• The EG 1-2-3 Hidden Fastener has been designed to work specifically and exclusively with the EverGrain 1" x 6" and 2" x 6" decking profiles.
Usage of the fastener with any other product has not been tested and is not recommended.
• Make safety of the workplace the prime consideration. Always wear the proper protective clothing and safety equipment.
• Framing supports should be straight and level with each other to ensure proper installation and an even surface.
• EG 1-2-3 Hidden Fasteners must be installed in accordance with the installation instructions. Deviation from these instructions may result in
unsatisfactory performance and may exclude coverage of your EG 1-2-3 Hidden Fastener under the limited warranty.
3/4" BOARD Screws
(included in packaging)