DeWalt DW369 - Manual (Page 16)

14
English
ADJUSTING DEPTH ADJUSTMENT LEVER (DW369 ONLY)
1. Loosen the screw securing the depth adjustment lever.
2. Remove the depth adjustment lever and rotate it to the desired
location, about 1/8 of a revolution.
3. Tighten the lever screw.
Blades
A dull blade will cause inefficient cutting, overload on the saw
motor, excessive splintering and increase the possibility of kickback.
Change blades when it is no longer easy to push the saw through
the cut, when the motor is straining, or when excessive heat is built
up in the blade. It is a good practice to keep extra blades on hand
so that sharp blades are available for immediate use. Dull blades
can be sharpened in most areas; see SAWS-SHARPENING in the
yellow pages.
Hardened gum on the blade can be removed with kerosene,
turpentine, or oven cleaner. Anti-stick coated blades can be used
in applications where excessive build-up is encountered, such as
pressure treated and green lumber.
ACCESSORIES
WARNING: Since accessories, other than those offered by
D E WALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk
of injury, only D
E WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory for your tool,
please contact D
E WALT Industrial Tool Co., 701 East Joppa Road,
Baltimore, MD 21286, call 1-800-4-D E WALT (1-800-433-9258) or
visit our website www.dewalt.com.
DO NOT USE WATER FEED ATTACHMENTS WITH THIS SAW.
VISUALLY EXAMINE CARBIDE BLADES BEFORE USE. REPLACE
IF DAMAGED.
RECOMMENDED BLADE TYPES
COMBINATION FRAMING - 5/8" Round arbor, 24 teeth
All purpose fast rip and cross cuts.
PRESSURE TREATED/WET LUMBER - 5/8" Round arbor, 20 teeth
Coated - Resistant to gum build-up
EXTREME DURABILITY - 5/8" Round arbor, 18 teeth
Coated, rock carbide
FINISHING - 5/8" Round arbor, 36 teeth
More teeth for finer finish cuts.
FAST CUT FRAMING - 5/8" Round arbor, 16 teeth
Fastest blade for rips and cross cuts
Three Year Limited Warranty
D E WALT will repair, without charge, any defects due to faulty
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
E WALT (1-800-
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have other
rights which vary in certain states or provinces.
In addition to the warranty, D E WALT tools are covered by our:
1 YEAR FREE SERVICE
D E WALT will maintain the tool and replace worn parts caused by
normal use, for free, any time during the first year after purchase.