Naim Audio NAP 500 - Manual (Page 10)

E8
10.1 General Connections Notes
The negative input and output connections are all common. The
mains earth should always be connected regardless of what
other equipment is used. This only grounds the case and the
electrostatic screen within the transformer, and is not connected
to the signal negative. In order to avoid hum loops, the signal
negative of the whole system should be connected to the mains
earth (ground) in one place.
10.2 Protection Notes
If the amplifier’s external case reaches 70°C due to prolonged
running at high power, the mains supply will be interrupted and
the illuminated logo will switch off until the amplifier has cooled
down. This may take up to thirty minutes.
10 NAPV 145 Installation and Operation
The NAPV 145 is a mono power amplifier intended for use in audio-visual systems. The NAPV
145 should be installed on a dedicated equipment stand intended for the purpose and should
be in its final location before connecting cables or switching on. Switch on the source and
preamplifier components, with the volume turned down, before switching on the NAPV 145.
The NAPV 145 power button is located on the front panel.
The NAPV 145 is heavy and care should be taken when lifting or moving it. Make sure that the
surface it is to be placed on can support the full weight.
OPERATION OF THE AMPLIFIER’S THERMAL PROTECTION
SUGGESTS PROLONGED USE AT TOO HIGH A VOLUME
LEVEL. YOUR LOUDSPEAKERS MAY BE AT RISK IF THIS IS THE
CASE. THE VOLUME SHOULD BE REDUCED.
10.3 Loudspeaker Cable and Connectors
Only Naim Audio speaker cable should be used to connect a
loudspeaker to the output of the NAPV 145. Custom Naim Audio
loudspeaker connectors are supplied to make the connection
and in order to comply with current European safety regulations
these should always be used.
DAMAGE TO THE AMPLIFIER MAY RESULT IF “HIGH
DEFINITION” CABLE OR ANY OTHER SPECIAL CABLE IS USED
TO CONNECT THE LOUDSPEAKERS.
Ensure when connecting speakers that they are “in phase”. That
is, the positive and negative connection orientation at both the
speaker and amplifier ends of the cable is the same for both
channels.
mains input
and fuse
signal input
NAPV 145
speaker
11 NAPV 145 Connections
11.1 NAPV 145 Rear
nc
-ve i/p
Input