Naim Audio StageLine - Manual (Page 2)

SAFETY INSTRUCTIONS
In order to comply with current European
safety regulations it is essential that the Naim
loudspeaker connectors supplied with amplifiers
and loudspeakers are used.
Do not under any circumstances allow anyone
to modify your Naim equipment without first
checking with the factory, your retailer, or your
distributor. Unauthorised modifications will
invalidate your guarantee.
Equipment must not be exposed to dripping or
splashing and no objects filled with liquid, such
as vases, should be placed on the equipment.
For your own safety do not under any
circumstances open Naim equipment without
first disconnecting it from the mains.
Warning: an apparatus with CLASS I
construction shall be connected to a mains
socket outlet with a protective earthing
connection.
Where the mains plug or an appliance coupler
is used as the disconnect device, the disconnect
device shall remain readily operable. To
disconnect the equipment from the mains
remove the mains plug from the mains outlet.
The following label is attached to the NAPSC:
This equipment has been tested and found
to comply with the relevant EMC and Safety
Standards, and, where applicable, also complies
with the limits for a class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio frequency
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications.
WA R N I N G
THIS APPARATUS
MUST BE EARTHED
Page Section
1 1 Connections
2 Mains Power
2 3 General Installation
4 4 Product Introduction
5 NAPSC
5 6 Headline
6 7 Stageline
8
8 Declaration of Conformity
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult your Naim retailer or an experienced
radio/TV technician for help.
Contents