Lenco IR-1650 - Manual (Page 3)

SETTING UP
Those steps for connecting your radio to your network
Step 1 Switching on the radio
Plug the cable from the AC adapter into the socket labeled 7.5V 1.2A DC on the back of the radio, then
switch on at the mains.
Caution: Use only the mains adapter supplied with the radio. Connecting a power supply with a different
rating will cause permanent damage to the radio and may be hazardous.
The display on the front of the radio will light up and say:
Then show
After a few seconds, it will shows :
If it complete the initialing, it will auto scan the ESSID as
Then it will list all the ESSID names it can find, you can select one of you want to use, maybe it will
request you input the correct WEP(Wired Equivalent Privacy) or WPA(Wi-Fi Protected Access) code. If
your network is not configured to need a WEP or a WPA code, the unit will connect to the ESSID auto
and success as
Or if you are requested to input the encryption, you can do as
1. Select the one you want to use
2. Then it will show you
Initializing
WiFi Network
Scanning
…….
Network OK
<your network>
Enter WPA/WEP key
LENCO
Internet Radio
SP Radio
ARM Powered