Mini 2009 Clubman - Manual (Page 121)

REFERENC
E
AT
A
GL
AN
C
E
CO
NT
R
O
LS
D
R
IV
ING
TI
P
S
MOB
IL
ITY
119
4. Screw out the respective bulb counterclock-
wise.
5. To insert the new bulb and reinstall the tail
lamp, proceed in reverse order.
Rear fog lamp*
21 watt bulb, P 21 W
The rear fog lamp is located in the left tail
lamp (see Tail lamps page
118 . <
License plate lamps
5 watt bulb, C 5 W
1. Using a screwdriver, push the lamp to the
left in the tab of the lamp housing, arrow 1.
2. Remove the lamp, arrow 2.
3. Replace the bulb.
4. Insert the lamp.
Center brake lamp
This lamp uses LED technology for operation. In
the event of a malfunction, contact your MINI
Dealer or a workshop that has specially trained
personnel working in accordance with the spec-
ifications of your MINI manufacturer.
Repairing a flat tire
Safety measures in the event of a break-
down:
Park the vehicle as far as possible from moving
traffic and switch on the hazard warning flash-
ers.
Turn the steering wheel until the front wheels
are in the straight-ahead position and engage
the steering wheel lock. Engage the parking
brake and shift into 1st or reverse gear or place
the selector lever in position P.
All passengers should be outside the vehicle and
in a safe place, e.g. behind a guardrail.
Erect a warning triangle or warning flasher at the
appropriate distance if necessary. Comply with
all safety guidelines and regulations.
<
In the event of a flat tire, different procedures
should be followed depending on the equip-
ment included in your vehicle:
> MINI Mobility System, refer to the following
section
> Run-Flat Tires, page 103
> Tire change with space-saver spare tire,
page
121
MINI Mobility System with onboard tool
kit and tire change set*
The MINI Mobility System with tire change set
and onboard tool kit is located under the floor
mat or the level load floor in the cargo bay.
1 Compressor, hose with manometer and plug
for cigarette lighter socket
2 Filling hose
3 Wheel stud wrench
*
4 Vehicle jack *
5 Torx insert bit for screwdriver
6 Flat screwdriver/Phillips screwdriver, towing
eyelet
7 Hub cover remover
8 Filling canister
Use of the MINI Mobility System may be
ineffective if the tire puncture measures
approx. 1/8 in/4 mm or more. Contact the near-
est MINI Dealer if the tire cannot be made driv-
able with the MINI Mobility System.
<
PDF Decrypter Trial
Website : http://www.softlay.org