Tow-starting, towing away – Mini 2007 Cooper User Manual
Page 115
113
1 Positive terminal
2 Negative terminal
Connect the jumper cables in the correct
order, so that no sparks which could cause
injury occur.
<
1.
Open the cover over the battery in the
engine compartment.
2.
Attach one terminal clamp of the plus/+
jumper cable to the positive terminal of the
battery or a starting-aid terminal of the vehi-
cle providing assistance.
3.
Attach the second terminal clamp of the
plus/+ jumper cable to the positive terminal
of the battery or a starting-aid terminal of
the vehicle to be started.
4.
Attach one terminal clamp of the minus/–
jumper cable to the negative terminal of the
battery or to an engine or body ground of
the assisting vehicle.
5.
Attach the second terminal clamp of the
minus/– jumper cable to the negative termi-
nal of the battery or to the engine or body
ground of the vehicle to be started.
Starting the engine
1.
Start the engine of the donor vehicle and
allow it to run for a few minutes at slightly
increased idle speed.
2.
Start the engine of the other vehicle in the
usual manner.
If the first start attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.
3.
Let the engines run for a few minutes.
4.
Disconnect the jumper cables by reversing
the above connecting sequence.
If necessary, have the battery checked and
recharged.
Never use spray fluids to start the
engine.
<
Tow-starting, towing
away
Observe the applicable laws and regula-
tions for tow-starting and towing vehi-
cles.
<
Do not transport any passengers other
than the driver in a vehicle that is being
towed.
<
Using a tow fitting
The screw-in tow fitting must always be carried
in the car. It can be screwed in at the front or
rear of the MINI.
It is stored in the onboard tool kit underneath
the cover on the right-hand side of the cargo
area, page
.
Use only the tow fitting provided with the
vehicle and screw it all the way in. Use the
tow fitting for towing on paved roads only. Avoid
lateral loading of the tow fitting, e.g. do not lift
the vehicle by the tow fitting. Otherwise the tow
fitting and the vehicle could be damaged.
<
Access to screw thread
Push out the rectangular cover panel in the
bumper at the recesses.
Online Edition for Part no. 01 41 0 013 069 - © 11/06 BMW AG