Altera ByteBlaster II - Manual (Page 25)

Info–3
How to Contact Altera
© July 2008 Altera Corporation ByteBlaster II Download Cable User Guide
How to Contact Altera
For the most up-to-date information about Altera® products, refer to the following
table.
Typographic Conventions
This document uses the typographic conventions shown below.
Table Info–2. How to Contact Altera
Contact (1) Contact Method Address
Technical support Website www.altera.com/support
Technical training Website www.altera.com/training
Email [email protected]
Product literature Website www.altera.com/literature
Altera literature services Email [email protected]
Non-technical support (General)
(Software Licensing)
Email [email protected]
Email [email protected]
Note to Table Info–2
(1) You can also contact your local Altera sales office or sales representative.
Table Info–3. Typographic Conventions (Part 1 of 2)
Visual Cue Meaning
Bold Type with Initial Capital
Letters Command names, dialog box titles, checkbox options, and dialog box options are shown
in bold, initial capital letters. Example: Save As dialog box.
bold type External timing parameters, directory names, project names, disk drive names, filenames,
filename extensions, and software utility names are shown in bold type. Examples: f
MAX
,
\qdesigns directory, d: drive, chiptrip.gdf file.
Italic Type with Initial Capital
Letters Document titles are shown in italic type with initial capital letters. Example: AN 75:
High-Speed Board Design.
Italic type Internal timing parameters and variables are shown in italic type.
Examples: t
PIA
, n + 1.
Variable names are enclosed in angle brackets (< >) and shown in italic type. Example:
<file name>, <project name>.pof file.
Initial Capital Letters Keyboard keys and menu names are shown with initial capital letters. Examples: Delete
key, the Options menu.
“Subheading Title” References to sections within a document and titles of on-line help topics are shown in
quotation marks. Example: “Typographic Conventions.”
Courier type Signal and port names are shown in lowercase Courier type. Examples: data1 , tdi ,
input. Active-low signals are denoted by suffix n , for example, resetn .
Anything that must be typed exactly as it displays is shown in Courier type. For example:
c:\qdesigns\tutorial\chiptrip.gdf . Also, sections of an actual file, such as a
Report File, references to parts of files (for example, the AHDL keyword SUBDESIGN ), as
well as logic function names (e.g., TRI ) are shown in Courier.
1., 2., 3., and
a., b., c., etc. Numbered steps are used in a list of items when the sequence of the items is important,
such as the steps listed in a procedure.
■ ● • Bullets are used in a list of items when the sequence of the items is not important.
v The checkmark indicates a procedure that consists of one step only.