Altera JNEye User Manual
Page 162
channel and the crosstalk noises are superimposed. This section describes how to set up crosstalk
simulation in JNEye.
The backplane model is provided as a 12-port S-parameter. It consists of both insertion loss and crosstalk
characteristics. However, JNEye requires you to add them one at a time (even if the loss and crosstalk
characteristics are from the same multiple-lane S-parameter file). Therefore, you are going to insert three
channel components during channel setup: one backplane victim channel and two backplane aggressor
channels.
Perform the following steps to add a victim channel:
1. Click Channel in the Link Designer and select Transmission.
2. Use the file browser to locate the channel model file Demo.s12p and add it to the channel list as
victim.
3. The JNEye Channel Wizard displays the Sdd21 characteristics of the middle lane (lane 2) in the 12-
port S-parameter.
4. Click OK to close the Channel Wizard.
5. Place the channel icon in the Link Designer.
Figure 3-10: Configure Victim Channel with JNEye Channel Wizard
UG-1146
2015.05.04
Constructing the Channel
3-11
Tutorial: PCI Express 8GT
Altera Corporation