Saab 2001 9-3 - Manual (Page 124)

124 OnStar - Telematics
Storing/Deleting Numbers in
Memory
(Nametags)
Storing a number
Your OnStar system can store up to 20
numbers (up to 32 digits each) in memory
that can be dialed by simply repeating the
”nametag.”
To store a number:
Deleting a Number from Memory
To delete a nametag:
Setting Tone or Voice Response
Your system comes from the factory with
voice responses to your commands to con-
firm that the system received the command
or number you intended. For example,
when you are entering a number, OnStar
repeats the number back to you. You may
change the system to respond with a tone
response if you prefer. A ready tone, a digit
tone, or a goodbye tone will respond instead
of the voice. All other responses will still be
by voice.
Units Remaining
OnStar keeps track of the amount of calling
time you have purchased and used in units.
The number of total remaining units is
stored within the OnStar system, and can be
accessed easily.
Adding More Calling Minutes / Units
You can charge additional calling units with
automatic refill by contacting OnStar, or by
authorizing automatic unit refill on the
OnStar Subscriber Website. For more infor-
mation about the OnStar Subscriber Web-
site, please see page 127.
Automatic Replenishment
If you run out of units during a call, your call
will be terminated and you will be connected
to OnStar for approval to replenish. You will
be warned at the beginning of a call when
you have ten or fewer calling units remain-
ing.
1 Press the
OnStar DOT
button
OnStar will respond
”Ready”
2 Say ”STORE” OnStar will respond
”Number Please”
3 Say the 1st
Digit
OnStar will repeat the
number
4 Say the 2nd
Digit
OnStar will repeat the
digit
Continue saying numbers in this manner
until finished
5 Say ”STORE”
again
OnStar will respond
”Nametag Please”
6 Say ”<new
nametag>”
OnStar will respond
”Again”
7 Say ”<new
nametag>”
OnStar will respond
”Once More”
8 Say ”<new
nametag>”
OnStar will respond
”Storing <nametag>”
1 Press the
OnStar DOT
button
OnStar will respond
”Ready”
2 Say ”DELETE” OnStar will respond
”Nametag Please”
3 Say
”<nametag>”
OnStar will respond
”Delete <nametag>,
YES or NO”
4 Say ”YES” OnStar will respond
”Deleting <nametag>”
1 Press the
OnStar DOT
button
OnStar will respond
”Ready”
2 Say ”Voice
Feedback”
OnStar will respond
”Voice Feedback is
now ON/OFF”
1 Press the
OnStar DOT
button
OnStar will respond
”Ready”
2 Say ”Units” OnStar will respond
”Verify or Add”
3 Say ”Verify” OnStar will respond
”You have # units
remaining”