Optoma STA200 - Manual (Page 2)

1 PB
NuForce STA200 Power Amplifier
FCC STATEMENTS
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SAFETY PRECAUTIONS
Observe the following Safety Precautions when operating the device.
• Only use the accessories that are included in the package.
• Do not expose the device to direct sunlight.
• Do not place the device in a damp condition or high humidity.
• Do not cover or block any ventilation openings of the device.
For proper ventilation, make sure there is at
10
cm
least 10cm
clearance at the back of the unit.
• Do not drop the device or subject it to severe impact.
• Do not operate the device during thunderstorms.
• Protect all cables and power cord from being walked on or pinched.
• Keep the device away from water.
• Unplug the power cord before cleaning. Wipe the device with a clean, dry cloth.
• Do not attempt to repair this device yourself.