Desa 102865-01 - Manual

www.desatech.com
TRIM KIT
INSTALLATION INSTRUCTIONS
Includes Hardware Kit 102865-01
Installation Instructions
Note: Firebox model may vary from that shown in Figure 2.
1. Remove packaging from three pieces of trim.
2. Locate the two adjusting plates with set screws and two shims
in the hardware packet.
If any of these pieces are missing or damaged, contact the dealer
where you purchased this kit or DESA at 1-866-672-6040 for
referral information. You can also visit DESAʼs technical service
web site at www.desatech.com .
3. Align shim under adjusting plate as shown in Figure 1.
4. Slide one end of adjusting plate/shim in slot on mitered edge
of top trim (see Figure 1).
5. Slide other end of adjusting plate/shim in slot on mitered edge
of side trim (see Figure 1).
Figure 2 - Attaching Trim to Firebox
Side Trim
Mitered Edge
Shim
Adjusting
Plate
Set Screws Top Trim
Slot
Slot
Assembled
Trim
Trim Hanging
Shoulder Screw
Locations
Hanging Notches
on Trim
Figure 1 - Assembling Trim
6. While firmly holding edges of trim together, tighten both screws
on the adjusting plate using a slotted screwdriver.
7. Repeat steps 2 through 6 for other side.
8. Place the assembled trim onto firebox cabinet. Align hanging
notches on trim with trim hanging shoulder screws (see Figure 2).
Tap trim firmly into place with palm of hand or rubber mallet
by engaging hanging notches around shoulder screws. Start at
one end of the trim and work around firebox until all notches
are fully engaged.