D-Link DES-1526 - Manual (Page 50)

43
Configure SNMP Trap:
Figure 28. Configure SNMP Trap Setting
Trap authentication fail: When checked, the dialog box of the
Trap authentication fail. A trap when authentication fails, the
Switch will trap the authentication failure even to the SNMP host.
Power on/power off & threshold above/below: When checked the
dialog box of the power on/power off & power threshold
above/below. A trap when the PoE port’s power turned on/turned
off ; or radio of the system power supply larger than or smaller
than the System power Threshold setting.
Add Trap: To create a recipient of SNMP traps generated by the
Switch’s SNMP agent, press the “Add Trap” button, and the
SNMP Trap Set window will pop up. You can fill in the community
name and trap IP address of the remote management station that
will serve as the SNMP host for the Switch and check the events
selection to enabled selected event traps.